TM  10-3930-638-24&P 4-4.    TRANSMISSION    MAINTENANCE    (cont) g. Low Clutch Assembly (cont). STEP LOCATION ITEM ACTION REMARKS CLEANING 18 WARNING Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable.  Wear  protective  goggles  and  gloves  and  use  only  in  a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use near open flame or exces- sive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air immediately, and get medical attention. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water immedi- ate] y, and obtain medical aid immediately. WARNING Wear safety glasses when drying parts with compressed air. Fail- ure to do so could cause serious injury to eyes and possible blind- ness. If you hurt your eyes or if a foreign object is blown into your eyes, seek medical attention immediately. Eearings  (2,4,8) Clean Use  cleaning  solvent  P-D-680.  Immerse bearings in cleaning solvent and move slowly up and down. Remove bearings. Strike larger side of cone against block of wood to dislodge solidified particles of lubricant, Immerse again in cleaning solvent.  Repeat  this  process  until  bear- ings  are  thoroughly  clean,  Dry  bearings with moisture-free compressed air. Direct air stream across bearing. Do not spin the  bearings  when  drying.  Rotate  bear- ings slowly by hand to facilitate drying All parts Clean 19 Use  cleaning  solvent  P-D-680.  Immerse parts in cleaning solvent and move slow- ly up and down until parts are thoroughly cleaned. Dry parts thoroughly using com- pressed air or clean cloths 4-210