TM 10-3930-638-24&P 4 - 4 .    T R A N S M I S S I O N    M A I N T E N A N C E    ( c o n t ) e. Transmission Housing (cont). STEP LOCATION ITEM ACTION REMARKS REASSEMBLY  (cont) 9 1. O-rings (22 and 24) Install Lubricate with OE10 (refer to cont) current lubrication order) m. Suction tube clip (20) Position On suction tube assembly (18) n. O-ring(19) Install Lubricate with OE10 (refer to current lubrication order) o. Suction tube assem- Position bly  (18) p. Lock washer (17) Install q. Cap screw (16) Install r. Two lock washers (15) Install s. Two cap screws (14) Install WARNING Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes and clothes and don’t breathe vapors. Do not use near open flame or excessive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air and medical attention immediately. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water and get medical aid immediately. t. Transmission hous- Clean Use solvent type cleaning fluid. Thoroughly ing (34) clean housing and tubes using clean, soft, absorbent, lintless cloth moistened with cleaning fluid. Dry thoroughly with clean, soft absorbent, Iintless cloth 10 Transmission a. O-ring(13) Install Lubricate with OE10 (refer to housing  (34), current lubrication order) front b.  Stud  (12) install c. Third speed pressure Install plug(11) 11 Transmission a.  Elbow  (10) Install housing  (34), b. Connector (9) Install rear c. Dipstick tube (8) Install d. Dipstick hose (7) Install e. Two hose clamps (6) Install f. Dipstick (5) Install g. Two dowel pins (4) Install h.  Magnetic  drain Install plug (3) 12 Transmission a. Two plugs (2) Install housing  (34), b. Plug (1) Install left side In elbow On dipstick tube 4-192   Change   1