| |
TM 10-3930-638-24&P
4 - 4 . T R A N S M I S S I O N M A I N T E N A N C E ( c o n t)
e. Transmission Housing (cont).
Transmission
housing (34)
All other parts
Clean
STEP
LOCATION
ITEM
ACTION
REMARKS
CLEANING (cont)
WARNING
Wear safety glasses when drying parts with compressed air. Fail-
ure to do so could cause serious injury to eyes and possible blind-
ness. If you hurt your eyes or if a foreign object is blown into
your eyes, seek medical attention immediately.
5
Transmission
Clean
Use cleaning solvent P-D-680. Thoroughly
housing (34)
clean interior and exterior of housing.
Dry thoroughly using moisture free com-
pressed air or clean cloths
6
AU other parts
Use cleaning solvent P-D-680. Immerse
parts in cleaning solvent and move slowly
up and down until parts are thoroughly
cleaned. Dry thoroughly using moisture
free compressed sir or clean cloths
INSPECTION
7
Inspect tubes for cracks, damage, wear or
evidence of leaking condition. If any of
these conditions are observed, remove and
replace tubes. Inspect housing for cracks,
damage, wear, pits, nicks and distortion.
if any of these conditions are observed,
replace housing
8
Inspect for cracks, pits, wear, distortion,
and damaged condition. If any of these
conditions are observed, replace part
REASSEMBLY
9
Transmission
a. Lubrication clutch
Position
housing (34)
tube (31)
b. Tube sleeve (33)
Position and
Over forward end of clutch tube (3 1).
press
Press firmly into bore of housing
NOTE
Tube ends must remain flush with face of housing.
Inspect
inspect
4-190 Change 1
|
