TM  10-3930-638-24&P 2-15.   FUEL   SYSTEM   MAINTENANCE   (cont) g. Fuel Strainer (cont). STEP LOCATION ITEM ACTION REMARKS REMOVAL/SERVICING 1. Engine  compart- ment,  left  side a. Hose clamp (1) Remove b. Fuel filter Disconnect From hose barb (3) hose  (2) and cap c. Hose barb (3) Remove d. Fuel shut-off Remove valve  (4) e. Elbow (5) Remove f. Fuel strainer Remove From  fuel  tank (6) CLEANING WARNING Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use near open flame or exces- sive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air immediately, and get medical attention. If contact with skin or clothes is made, flush with large amounts of water, If contact with eyes is made, wash eyes with water immedi- ately, and obtain medical aid immediately. WARNING Wear safety glasses when drying parts with compressed air. Failure to do so could cause serious injury to eyes and possible blindness. If you hurt your eyes or if a foreign object is blown into your eyes, seek medical attention immediately. 2 3 Fuel shut -off valve Clean Use  cleaning  solvent  P-D-680.  Immerse (4) and fuel and move slowly up and down until strainer  (6) all foreign material is dissolved. Dry thoroughly  with  compressed  air All  other  parts Clean Use  cleaning  solvent  P-D-680.  Dry  thor- oughly 2-60