| |
TM 10-3930-638-24&P
4-4. TRANSMISSION MAINTENANCE (cont)
b. Converter Housing (cont)
STEP
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (cont)
22
Converter
a.
housing,
rear
b.
c.
d.
e.
f.
Stator
a.
support
b.
Pin (27) and reverse
Install
idler gear shaft (26)
Idler gear shaft (24)
Install
and lockball (25)
Stud (22 and 23)
Install
Transmission temper-
Install
ture switch (20)
and lock washer
(33)
Pipe plug (21)
Install
Converter housing
Position
sleeve { 19 )
Expander spring
Install
(18)
Piston ring (17)
Install
Tap in position with soft hammer
Place lockball (25) in position on gear
shaft (24), then, insert gear shaft through
its hole in rear of housing and tap into
position with soft hammer
Apply loctite to threads
Position sleeve with tab aligned with cast
slot in converter housing. Press sleeve
into housing until it shoulders in housing
as shown. Use two inches diameter bar
stock
Expander spring gap must be
from piston ring hook joint
NOTE
In the following step, part number etched on bearing must be up.
c. Bearing
Install
Press using suitable size sleeve
180 degrees
d. Retaining ring (7)
Install
Converter
a. Stator support (15)
Position
Align holes in support with converter
housing,
housing holes, then tap support into pos-
rear
ition as shown
4-159
|
