| |
TM 10-3930-638-24&P
4-4. TRANSMISSION MAINTENANCE (cont)
a Torque Converter Group (cont).
Install
STEP
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (cont)
30
Oil baffle
Oil seal (26)
Install with lip of seal positioned as shown
31
Converter
Oil baffle (25)
Install
Apply a light coat of thread sealant to
housing
outer diameter of oil baffle of counter
bore in converter housing as shown. Im-
mediately remove any excess sealant that
could enter oil circuit. Position oil baffle
puller screw holes 15 to 30 degrees either
side of vertical center line. Tap baffle
(on outside diameter only) into position
until baffle shoulders in converter hous-
ing; see illustration below
32
Impeller
a. O-ring (24)
Install
b. Impeller hub
Install
gear (23)
c. Lock tab (22)
Position
d. Eight screws (21)
Install
Bend lock tabs (22) over head of screws
CAUTION
In following step, take care not to damage oil baffle oil seal (26)
33
Converter
a. Impeller (20)
Install
housing
4-147
|
