TM  10-3930-638-24&P 4-4   TRANSMISSION   MAINTENANCE   (cont) a. Torque Converter Group (cont). STEP LOCATION ITEM ACTION REMARKS REASSEMBLY  (cont) Converter housing, front a. Screws (49) and Install lock washers (50) Install one screw and lock washer in front and one in rear. Use a slide type hammer puller as shown, and pull reverse clutch gear toward front of converter housing to move  reverse  and  second  clutch  assembly forward to align retaining ring groove in bearing with retaining ring (52) in housing. Be sure retaining ring (52) is in full position in ring groove before removing pliers. Remove aligning stud and install screws (49) and lock washers (50); tighten screws to 37-41 pounds foot torque Install b. Gasket (48) and Position  new  gasket  on  screen  assembly; screen assembly (47) install screen assembly and tighten to 10-15 pounds foot torque 4-145