| |
TM 10-3930-638-24&P
4-3. FUEL SYSTEM MAINTENANCE (cont)
b. Fuel Injection Pump (cont).
b. Governor control
Install
cover (22)
STEP
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (cont)
Back-out low idle screw (41 ) and push
(cont)
throttle lever (36) into shutoff position.
Move cover (22) down toward pump in a
position further toward drive shaft end
than normal. Just before cover (22)
touches housing, slide cover into align-
ment with housing
c. TWO lock
Position
washers (16 and 17)
d. Grounding strap (15)
Position
e. Three washers (12),
Install
Tighten to 3545 pounds inch torque
lock washers (11)
and screws (1 O)
f. Washer ( 14) and
Install
two nuts (13)
g. Connector (21)
Install
Tighten to 200 pounds inch torque
h. Throttle shaft
Wire in wide
assembly (37)
open position
i. Drive shaft (5)
Remove
j. Pilot tube seal (8)
Install
36
Drive
Roll pin (7)
Install
shaft (5)
NOTE
Place two new seals (6), drive shaft (5), lock washer (4), nut (3),
spring (2), and thrust plunger ( 1 ) in a small cloth bag; these parts
will be assembled when fuel injection pump is installed. Attach
bag to fuel injection pump securely.
37
Housing, sides
a. Two gaskets (126)
Position
b. Two timing line
Position
covers (125)
c. Four screws (1 24)
Install
Tighten to 15-20 pounds inch torque
d. Eight washers
Install
(113) and four
fuel line
connector screws
(112)
e. Two head
locking screws
(63)
Tighten
To 360 pounds inch torque
4-127
|