| |
TM 10-3930-638-24&P
4-3. FUEL SYSTEM MAINTENANCE (cont)
b. Fuel Injection Pump (cont).
On screw (25)
On screw (25)
On spacer, in recess
On spacer adjusting arm (29)
Finger tight
STEP
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (cont)
b. Screw (30)
Install
(cont)
c. Spring retainer (26)
Install
d. Throttle lever
Position
spring (27)
e. Spacer adjusting
Position
arm (29)
f. Throttle lever
Position
assembly (28)
g. Screw (25), spring
Install
retainer (26), and
throttle lever
spring (27)
h. Throttle lever
Position; cross ends
spring (27)
over each other
to clamp throttle
lever (28) and arm
(29) together
i. Screw (25)
Tighten
To 35-40 pounds inch torque
34
Governor
a. Solenoid frame
Position
On governor control cover (22)
control
and arm
cover (22)
assembly (24)
b. Two insulating
Install
washers (20)
and washers (19)
c. Two nuts(18)
Install
Tighten to 20-25 pounds inch torque
35
Housing,
a. Gasket (23)
Position
top
CAUTION
Exercise extreme care in the following step when installing
governor control cover. It is possible to locate solenoid shutoff
arm on the wrong side of linkage hook (54) tab, thus locking
linkage hook in full run position, blocking all governor action.
If this condition exists, engine may accelerate to dangerously high
speeds when started.
4 - 1 2 6
|