| |
TM 10-3930-638-24&P
4-2. ENGINE MAINTENANCE (cont)
d. Crankshaft and Main Bearings (cont).
5
STEP
LOCATION
ITEM
ACTION
REMARKS
INSPECTION (cont)
NOTE
(cont)
When connecting rod journals are worn more than 0.002 inch,
grind undersize to following dimensions:
Outer Diameter
Grind
Undersize (inch)
to (inches)
0.002
2.2460 to 2.2470
0.010
2.2380 to 2.2390
0.020
2.2280 to 2.2290
0.030
2.2180 to 2.2190
If one or more journals are to be ground, then grind all journals.
e. Crankshaft connect-
Measure
Measure 90 degrees from first measurement
ing rod journals
for out-of-roundness. If out-of-roundness
exceeds 0.0005 inch, regrind journal
NOTE
If crankshaft was reground, repeat step 5 of inspection.
6
Crankshaft gear (9)
Inspect
Inspect for cracks, damage, missing or
broken teeth, scoring, pits and wear. If
any of these conditions observed, replace
gear
7
Center main
Center main bear-
a. Remove
Slide out
bearing cap (6)
ing liners (13)
b. Inspect
Inspect for cracks, scoring, pitting, flaking,
or signs of overheating. Check liner back
for bright spots. Replace if any of these
conditions observed
c. Measure thrust Use micrometer. Replace if thickness less
surface thick-
than 0.1025 inch
ness
4-29
|