| |
TM 10-3930-638-24&P
4-2. ENGINE MAINTENANCE (cont)
c. Crankshaft Oil Seal Retainer Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
CLEANING (cont)
4
Cylinder
Gasket (5)
Remove traces of gasket using cleaning
block, rear
area
solvent P-D-680. Dry with moisture free
compressed air
INSPECTION
5
All parts
Check for cracks, damage and distortion.
Replace part if any of these conditions
observed
6
Cylinder
Gasket (5) area
Check that all traces of gasket (5) removed
block, rear
INSTALLATION
7
Crankshaft oil
a. Rear oil seal
On press
seal retainer
retainer (7)
assembly
b. Oil seal (6)
Press into retainer until seal is flush with
rear of retainer
8
Cylinder
a. Gasket (5) area
Coat
Apply Permatex 2 from lower screw holes
block, rear
to bottom of block
Clean
Inspect
Inspect
Position
Install
4-22
|
