TM  10-3930-638-24&P 3-30.   HYDRAULIC   LIFT   SYSTEM   MAINTENANCE   (cont) c. Sideshift Cylinder Assembly (cont). STEP LOCATION ITEM ACTION REMARKS INSPECTION/REPAIR  (cont) 8 REASSEMBLY 9 10 11 12 Gland (25) Piston (18) Rod (26) Cylinder (27) TESTING 13 Sideshift  cyl- inder assembly All other parts Inspect Replace  if  damaged,  cracked,  split,  grooved or scored a. Seal (24) Install Seal  lip  towards  cylinder b. Wiper (23) Install Lip  towards  rod c. Back-up ring (22) Install Curved  side  towards  O-ring  (21) d. O-ring (21) Install e. Plug (20) Install a. Seal loader ring (17) Install b. Seal (16) Install On seal loader ring(17) c. Two wear rings (15) Install CAUTION Use care when performing following step not to damage seal or wiper. a. b. c. d. Gland assembly (19) Lubricate  and Use  clean  hydraulic  oil  (refer  to  current slide on rod (26) lubrication order) Piston assembly (14) Slide on rod (26) Small  diameter  recess  towards  rod  (26) Washer (13) and cap Install Tighten to 200-220 pounds foot torque screw (12) Seal (16) Lubricate Use clean hydraulic oil (refer to current lubrication order) CAUTION Use extreme care not to damage rings or seals when performing following step. a. Rod (26), gland as- Install as an sembly (19), and assembly piston assembly (14) b. Gland assembly (19) Position  and Tighten to 150-200 pounds foot torque tighten Cylinder port (port oppo- a. Connect hydrau- site rod end) lic hose to port (hose must have a 7/16-20 fitting on end) b. Connect other end of hose to test  hydraulic pump 3-229