| |
TM 10-3930-638-24&P
3-30. HYDRAULIC LIFT SYSTEM MAINTENANCE (cont)
c. Sideshift Clinder Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL (cont)
CAUTION
Support sideshift cylinder assembly while performing following
step to prevent it from falling.
e. Two cap screws (8)
Remove
and lock washers (9)
f. Cylinder mounting
Remove
strap (10)
g. Sideshift cylinder
Remove by pulling
assembly (11)
out from side of
carriage assembly
DISASSEMBLY
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don’t breathe vapors. Do not use near open flame or exces-
sive heat and don’t smoke when using it. Failure to do so could
cause serious injury. If you become dizzy while using cleaning
solvent, get fresh air immediately, and get medical attention. If
contact with skin or clothes is made, flush with large amounts of
water. If contact with eyes is made, wash eyes with water immedi-
ately, and obtain medical aid immediately.
2
Sideshift
a. Sideshift cylinder
Clean all exterior
Use cleaning solvent P-D-680
cylinder
assembly (11)
surfaces
assembly (11)
b. Gland assembly (19)
Loosen
c. Rod (26), gland as-
Remove as an
sembly (19), and
assembly
piston assembly (14)
d. Cap screw (12) and
Remove
washer (13)
e. Piston assembly (14)
Remove
f. Gland assembly (19)
Remove
3
Piston
a. Two wear rings(15)
Remove and
assembly (14)
discard
b. Seal (16)
Remove
c. Seal loader ring (17)
Remove and
discard
3-227
|
