| |
TM 10-3930-638-24&P
3-30. HYDRAULIC LIFT SYSTEM MAINTENANCE (cont)
b. Tilt Cylinder Assemblies (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don’t breathe vapors. Do not use near open flame or exces-
sive heat and don’t smoke when using it. Failure to do so could
cause serious injury. If you become dizzy while using cleaning
solvent, get fresh air immediately, and get medical attention. If
contact with skin or clothes is made, flush with large amounts of
water. If contact with eyes is made, wash eyes with water immedi-
ately, and obtain medical aid immediately.
1
Vehicle side,
a. Hose fitting (1 and 2)
Clean, loosen,
Use clean cloth moistened with cleaning
left or right
disconnect and
solvent P-D-680
cap
b. Adapter (3)
Remove
Cap tilt cylinder port
c. Elbow (4)
Remove
Cap tilt cylinder port
d. Two retaining rings (5)
Remove
e. Pin (6)
Remove
f. Nut (7), lock washer
Remove
(8), and cap screw (9)
g. Rod (10)
Remove
h. Pin(n)
Remove
i. Tilt cylinder assem-
Remove to clean
bly (12)
work area
DISASSEMBLY
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don’t breathe vapors. Do not use near open flame or exces-
sive heat and don’t smoke when using it. Failure to do so could
cause serious injury. If you become dizzy while using cleaning
solvent, get fresh air immediately, and get medical attention. If
contact with skin or clothes is made, flush with large amounts of
water. If contact with eyes is made, wash eyes with water immedi-
ately, and obtain medical aid immediately.
Tilt cylinder
a. Tilt cylinder assembly
Clean all exterior
Use cleaning solvent P-D-680
assembly (12)
(12)
surfaces
b. Three lubrication
Remove
fittings (13)
3-220
|
