TM 10-3930-638-24&P 2-14. ENGINE MAINTENANCE (cont) d.  Intake  Manifold  (cont) . STEP LOCATION ITEM ACTION REMARK REMOVAL Engine,  left  side a Tube (1) Disconnect From  elbow  (2) 1. b. Elbow (2) Remove c. Filter fitting Remove (3) d. Hose clamp (4) Loosen WARNING If NBC exposure is suspected, all air filter media should be handled by personnel  wearing  protective  equipment.  Consult  your  unit  NBC  Officer or NBC NCO for appropriate handling or disposal procedures. e. Air cleaner hose Disconnect and Remove hose clamp  (4) (5) remove f.  Delivery  tube Disconnect and From spray nozzle (7) (6) remove g. Spray nozzle (7) Disconnect and remove h. Washer (8) Remove i.  Adapter  (9) Remove j. Gasket (10) Remove k. Five nuts (11) Remove Support  intake  manifold 1. Three washers (12) Remove (14) m. Two washers (13) Remove 2 Cylinder a Intake manifold Remove (14) b. Gasket (15) Remove  and Discard CLEANING WARNING Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes and clothes and don’t breathe vapors. Do not use near open flame or excessive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air immediately, and get medical attention. If contact with akin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water immediately, and obtain medical aid im- mediately. WARNING Wear safety glasses when drying parts with compressed air. Failure to do so could cause serious injury to eyes and possible blindness. If you hurt your eyes or if a foreign object is blown into your eyes, seek medical atten- tion  immediately. All parts clean Use cleaning solvent P-D-680 Dry thoroughly with com pressed  air Change   5   2-33