TM  10-3930-638-24&P 3-24. STEERING SYSTEM MAINTENANCE (cont) b. Steering Gear (cont). 2 STEP LOCATION ITEM ACTION REMARKS DISASSEMBLY  (cont) c. Seven hex bolts (2) Loosen  and (cont) remove CAUTION Do not attempt to remove guide pin from inside center of end cover (3). Guide pin is press fit in the end cover and is not ser- viceable  separately. d. End cover (3) Loosen  and Lightly tap sides with soft hammer to remove loosen from rotor seal (4) and seal retain- er (5). Washer (6) and commutator (7) may be removed with end cover (3) 3 Housing (43) a. Rotor seal (4) and Remove Loosen  seal  retainer  (5)  by  bumping  side- seal retainer (5) ways with a soft hammer, and remove seal (4) and retainer (5). Discard seal (4) b. Wear washer (6) Remove From housing (43) or end cover (3) and  commutator  (7) c. Commutator ring (8) Remove  from Remove  with  a  sliding  and  lifting  motion manifold  (9) d. Manifold (9) Remove  from Remove  with  a  sliding  and  lifting  motion rotor set (11) CAUTION Rotor set (11) requires special attention in handling to avoid nicks  and  scratching.  When  handling  rotor  set,  apply  pressure  to rotor by grasping rotor and urging into contact with stator. Remove  as  an Grasp spacer (12) and remove assembly assembly with a sliding and lifting motion e. Rotor set (11), spacer  (12)  and drive link (10) 3-164