| |
TM 10-3930-638-24&P
3-20. AXLES AND DIFFERENTIAL CARRIER ASSEMBLIES MAINTENANCE (cont)
b. Rear Axle Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
1
Axle housing
a. Roller jack
Position under
axle assembly
b. Clamp (1)
Loosen
c. Vent hose (2)
Disconnect
d. Connector (3)
Remove
2
Bottom rear
a. Eight nuts (4), washers
Remove
of vehicle
(5 and 6), and cap
screws (7)
b. Two axle support
Remove
plates (8)
c. Rear axle assembly
Lower roller
(9)
jack, move out
of position and
remove to work
area
INSTALLATION
3
Bottom rear
a. Rear axle assembly
Using roller jack,
of vehicle
(9)
move into posi-
tion and raise
b. Two axle support
Position
plates (8)
c. Eight cap screws (7),
Install
washers (6 and 5),
and nuts (4)
4
Axle housing
a. Connector (3)
Install
b. Clamp (1)
Position
On vent hose (2)
c. Vent hose (2)
Connect to
If necessary, make hose from FSCM 81343
connector (3)
P/N SAE30R2TYPE1-141D; cut to
32 inches long
d. Clamp (1)
Tighten
e. Axle assembly fill
Check lubricant
Para 2-39d, step 4
plug
level and add
if necessary
3-141
|