| |
TM 10-3930-638-24&P
3-20. AXLES AND DIFFERENTIAL CARRIER ASSEMBLIES MAINTENANCE (cont)
a. Front Axle Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
1
Axle housing
a. Roller jack
Position under
axle assembly
b. Clamp (1)
Loosen
c. Vent hose (2)
Disconnect
d. Connector (3)
Remove; plug
port in axle
housing
2
Bottom front
a. Eight nuts (4),
Remove
of vehicle
washers (5 and 6),
and cap screws (7)
b. Two axle support
Remove
plates (8)
c. Front axle assembly
Lower roller jack,
(9)
move out of
position and
remove to work
area
INSTALLATION/REPLACEMENT
3
Bottom front
a. Front axle assembly
Using roller jack,
of vehicle
(9)
move into posi-
tion and raise
b. Two axle support
Position
plates (8)
c. Eight cap screws (7),
Install
washers (6 and 5),
and nuts (4)
4
Axle housing
a. Connector (3)
Install
b. Clamp (1)
Position
On vent hose (2)
c. Vent hose (2)
Connect to con-
If necessary, make hose from
nector
FSCM 81343 P/N
SAE30R2type 1-1-41D;
cut to 27 inches long
d. Clamp (1)
Tighten
e. Axle assembly fill
Check lubricant
Para 2-39d, step 4
plug
level and add
if necessary
3-139
|