| |
TM 10-3930-638-24&P
3-15. WIRING HARNESS REPLACEMENT (cont)
a. Front Wiring Harness (cont)
LOCATION
ITEM
ACTION
REMARKS
STEP
REMOVAL (cont)
From clamp (11 ) and end panel
From harness wire
From clamps (15) and instrument panel
6
Right hand
instrument
end panel
a. Nut (8), lock
washer (9) and
cap screw (10)
b. Clamp (11)
Remove
Spread and
remove
Remove
a. Three nuts (12),
lock washers (13)
and cap screws (14)
7
Instrument
panel front
From clamps (19) and side panel
a. Three nuts (16),
lock washers (17)
and cap screws (18)
Remove
8
Left hand
instrument
side panel
From vehicle
From harness (para 2-28e)
a. Front wiring harness
b. Warning light diodes
Remove
Grasp and pull
9
Front wiring
harness
INSTALLATION
On vehicle
Over harness and against instrument pane
mounting holes
Until clamps (7, 11, 15 and 19) are se-
curely mounted
Position
New front wiring
harness
10
Position
Install and
tighten
a. Clamps (7, 11, 15
and 19)
b. Cap screws (6, 10,
11
Instrument
panel
14 and 18), lock
washers (5, 9, 13,
and 17) and nuts
(4,8, 12 and 16)
New tie straps (1,
2 and 3)
All harness leads
Around harness, hydraulic return hose and
brake tube
To electrical components. Observe tags
on component terminals for correct
connection
Harness connectors (para 2-28e)
Loop and tie
Connect
12
a.
b.
c.
d.
Push on
Check
Warning light diodes
All electrical systems
For proper operation
3-119
|
