TM  10-3930-638-24&P 3-13.   STARTER   AND   SOLENOID   REPAIR   (cont) STEP ACTION REMARKS REASSEMBLY  (cont) (cont) 19 20 21 22 Brush holder (37, 38) Field frame (7) Center bear- ing  (20) Armature (10) e. Connector (2) Position f. Lock washer (48) Install  and and screw (47) tighten NOTE Always replace brushes and springs as a set. a. Two brushes (39) b. Four screws (40 and 41) c. Two brush springs (35) a. Two control assem- blies  (46) b. Four screws (43) c. Four lock washers (45) d. Four nuts (44) e. Two brush support pins  (36) f. Two brush holder assemblies (37, 38) g. Two ground brush leads (42) a. Sleeve bearing (21) b. Oil seal (19) c. Gasket (18) a. Center bearing as- sembly  (17) b. Washer (16) c. Drive assembly ( 15) and  armature  (10) shaft d. Stop collar (13) e. Armature (10) f. Retaining ring (14) Install Install  and tighten Install Position Install Install Install Position and  install Connect Install Install Install Install Install Lubricate  and position Position Position Install Assemble with holders (37, 38) Place in control assembly (46). Push holders and spring to bottom of control assembly and rotate spring to engage the slot in the assembly If  removed Apply light coat &lubricant to drive end of  armature  shaft.  Slide  drive  assembly onto shaft with pinion away from armature Face cupped surface of collar away from armature Stand on a wood block with commutator down Tap into place with small block of wood and a hammer 3-110