| |
TM 10-3930-638-24&P
3-13. STARTER AND SOLENOID REPAIR (cont)
STEP
LOCATION
ITEM
ACTION
REMARKS
DISASSEMBLY (cont)
3
Center bearing
a. Gasket (18)
Remove and
(20)
discard
b. Oil seal (19)
Remove and
discard
NOTE
Do not remove sleeve bearing (21) unless replacement is required.
c. Sleeve bearing (21)
Remove
4
Drive housing
a. Two screws (22) and
Remove
(53)
lock washers (23)
b. Solenoid switch (24)
Remove
Pull straight out from drive housing (53)
c. Plunger spring (25)
Remove
From plunger (32)
d. Spring pin (26)
Remove
e. Nut (27)
Remove
f. Screw (28)
Remove
g. Two seal washers (29)
Remove
h. Shift lever (30)
Remove
i. Boot (31)
Remove
j. Plunger (32)
Remove
k. Pin (33)
Remove
NOTE
Do not remove sleeve bearing (34) unless replacement is required
as per inspection.
1. Sleeve bearing (34)
Remove
5
Field frame (7)
a. Two brush springs
Release
(35)
b. Two brush support
Remove
pins (36)
c. Two brush holders
Remove
Remove as one assembly
(37, 38), two brushes
(39), four screws
(40, 41), and two
brush springs (35)
d. Two ground brush
Disconnect and
leads (42)
and remove
e. Two screws (40)
Remove
f. Two screws (41)
Remove
g. Two brush holders
Disassemble
(37, 38), brushes (39)
and separate
and brush springs-
(35)
3-105
|
