| |
TM 10-3930-638-24&P
3-5. ENGINE MAINTENANCE (cont)
d. Separation of Engine and Transmission (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
[INSTALLATION
4
5
Transmission
a.
b.
Flywheel housing a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
One guide stud
Flex plate
Flywheel
Two studs (9)
Transmission
Two lock washers (8)
and nuts (6)
Ten lock washers (8)
and cap screws (7)
Eight cap screws (5)
Nuts (6) and cap
screws (7)
Dust cover (4)
Three washers (3), lock
washers (2) and cap
screws (1)
Transmission supports
and hard ware
Install
Rotate
Rotate
Install and
tighten
Position
Install
Install
Install and
tighten
Tighten
Position
Install and
tighten
Remove
In a lower flex plate nut
Until guide stud is at bottom center of
transmission
Until flex plate cap screw hole is aligned
with guide stud at bottom of transmission
If removed
Against engine flywheel housing. Align
guide stud with flywheel, and studs (9)
and transmission housing
Rotate flywheel and flex plate and install
at least one cap screw before removing
guide stud. After all eight cap screws
are snug, rotate flywheel and flex plate
and tighten to 25-30 pounds foot torque
Until transmission is securely mounted
On flywheel housing
Until cover (4) is securely mounted
From transmission
3-48
|