| |
TM 10-3930-638-24&P
2-53. BODY, CAB AND HOOD MAINTENANCE (cont)
f. Front Cover Panel (cont).
All parts
Inspect
STEP
LOCATION
ITEM
ACTION
REMARKS
CLEANING
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don’t breathe vapors. Do not use near open flame or exces-
sive heat and don’t smoke when using it. Failure to do so could
cause serious injury. If you become dizzy while using cleaning
solvent, get fresh air immediately. and get medical attention. If
contact with skin or clothes is made, flush with large amounts of
water. If contact with eyes is made, wash eyes with water immed-
iately, and obtain medical aid immediately.
2
All parts
Clean
Use cleaning solvent P-D-680. Dry
thoroughly. Remove rust using stiff
wire brush
INSPECTION
3
Replace if cracked, damaged, broken,
bent, distorted, missing or damaged
threads
INSTALLATION
4
Operator’s com-
a. Flange mounted
Position on panel
partment
bearing (9)
(5)
b. Two cap screws (8),
Install
lock washers (7),
and nuts (6)
c. Front cover panel (5)
Position
d. Dipstick tube assembly Connect to panel
hose
(5) tube
e. Clamp (4)
Tighten
f. Six washers (3), lock
Install
washers (2), and cap
screws (1)
g. Dipstick
Install
h. Axle disconnect lever
Install
knob
2-380
|