| |
TM 10-3930-638-24&P
2-53. BODY, CAB AND HOOD MAINTENANCE (cont)
b. Fenders (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
CLEANING
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don’t breathe vapors. Do not use near open flame or exces-
sive heat and don ‘t smoke when using it. Failure to do so could
cause serious injury. If you become dizzy while using cleaning
solvent, get fresh air immediately, and get medical attention. If
contact with skin or clothes is made, flush with large amounts of
water. If contact with eyes is made, wash eyes with water immed-
iately, and obtain medical aid immediately.
5
All parts
Clean
Use cleaning solvent P-D-680. Dry
thoroughly. Remove rust using stiff
wire brush
INSPECTION
6
All parts
Inspect
Replace if cracked, damaged, bent,
broken, distorted or threads damaged
INSTALLATION
7
Engine compart-
a. Fender (18)
Position
ment, rear left
b. Nine washers (17), five
Install
Connect ground wire when installing rear
or right side
cap screws ( 16), lock
left fender
washers (15), and
nuts (14)
8
Left or right
a. Two plugs (13)
Install
front fender (8)
b. Washer (12), cap screw
Install
Do not tighten; loosely install in fender
(11), lock washer (10),
and nut (9)
9
Console support
a. Fender (8)
Position
Position assembled cap screw (11), and
bracket, left or
washer (12), in slot in console support
right side
bracket
b. Nut (9)
Tighten
c. Cap screw (7), lock
Install
washer (6), and nut (5)
10
Chassis, front
a. Two washers (4)
Install
left or right
b. Two cap screws (3)
Install
side
c. Two lock washers (2)
Install
d. Two nuts (1)
Install
2-369
|