TM 10-3930-638-24&P 2-52.   FRAME   AND   TOWING   ATTACHMENTS   MAINTENANCE   (cont) a. Roll Over Protective Structure (cont). Use  hoist STEP LOCATION ITEM ACTION REMARKS REMOVAL 1 Operator’s com- a. Three wire leads Tag and disconnect Located at bottom of ROPS, two on left, partment one on right b. Roll over protective Secure Attach  hoist structure  (9) c. Two nuts (1), washers Remove (2), reinforcing plates (3),  washers  (4),  and cap screws (5) d. Two nuts (6), lock Remove washers (7), and cap screws (8) e. Roll over protective Remove structure  (9) f. Two nuts (10), lock Remove washers (11), washers (12), and cap screws  (13) g. Two brackets (14) Remove NOTE Don’t perform following step unless inspection indicates re - placement of canopy headlining (15) is necessary. h. Canopy headlining Remove only if (15) damaged CLEANING WARNING Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use near open flame or exces- sive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air immediately, and get medical attention. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water immed- iately,  and  obtain  medical  aid  immediately. 2 ALL parts Clean Use  cleaning  solvent  P-D-680.  Dry thoroughly 2-356 CHANGE 2