TM  10-3930-638-24&P 2-43.   SERVICE   BRAKE   MAINTENANCE   (cont) c. Brake Pedal and Declutch Pedal (cont). STEP LOCATION ITEM ACTION REMARKS REMOVAL 1 Front chassis, a. Cotter pin (1) and Remove bottom  left clevis pin (2) side b. Two springs (3) Unhook  and  remove  Use  pliers c. Nut (4), lock washer Loosen  and  remove  Support  eye  rod  (7) (5) and cap screw (6) d. Eye rod (7) Pull and remove From pivot pin (8) e. Pivot pin (8) Pull and remove Support pedals (9 and 10) f. Declutch pedal (9) Lower  and From  vehicle and brake pedal remove (10) g. Lock nut (11) Loosen Unscrew from nut on brake valve push rod h. Brake pedal yoke Remove Unscrew from brake valve push rod (12) DISASSEMBLY 2 Pedals (9 and a. Two grease fittings Remove From  pedals 10) (13) b. Two lock nuts (14) Loosen  and From  pedals and cap screws (15) remove CLEANING WARNING Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable.  Wear  protective  goggles  and  gloves  and  use  only  in  a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use near open flame or exces- sive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air immediately, and get medical attention. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water immedi- ately,  and  obtain  medical  aid  immediately. WARNING Wear safety glasses when drying parts with compressed air. Fail- ure to do so could cause serious injury to eyes and possible blind- ness. If you hurt your eyes or if a foreign object is blown into your eyes, seek medical attention immediately. 2-316