TM  10-3930-638-24&P 2-42. PARKING BRAKE MAINTENANCE (cont) b. Parking Brake Assembly (cont). STEP LOCATION ITEM ACTION REMARKS REPAIR  (cont) NOTE 12 (cont) Make certain lining is firmly clamped to brake shoe, locating C-clamps as close to rivet holes as possible. e. Rivet heads F o rm INSTALLATION/REPLACEMENT 13 Transmission a. Four spacers (14) Posit ion rear b. Backing plate (13) Position c. Four lock washers (12) Install and and cap screws (11) tighten d. Actuating lever (10) Position e. Shoe and lining (9) Position f. Two return springs (8) Install g. Brake flange (7) Push  on Use rivet set, starting on center rivets and  moving  outwards  toward  sides  and ends of lining On  backing  plate  (13) On transmission Tighten to 81-97 pounds foot torque On  backing  plate  pawl On  backing  plate  pawls On brake shoes; top spring in inner holes on shoes; bottom spring in center holes on shoes. Transmission  output  shaft NOTE Use impact wrench to tighten nut (4). If impact wrench is not available,  temporarily  install  two  bolts  in  brake  flange  (7),  and insert  retainer  bar  between  bolts  to  prevent  flange  from  turning while tightening nut (4). h. New seal (6), washer (5) Install and tighten Tighten nut to 600-700 pounds foot and nut (4) torque i. Brake drum (3) Position On brake flange (7) j. Six lock washers (2) Install and tighten Tighten to 41-49 pounds foot torque and cap screws (1) k. Parking brake linkage Reconnect and Para 2-42a adjust Change 1       2-281

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business