| |
TM 10-3930-638-24&P
2-39. AXLES AND DRIVE SHAFT ASSEMBLIES MAINTENANCE (cont)
c. Rear Drive Shaft Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION/REPLACEMENT
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don’t breathe vapors. Do not use near open flame or exces-
sive heat and don’t smoke when using it. Failure to do so could
cause serious injury. If you become dizzy while using cleaning
solvent, get fresh air immediately, and get medical attention. If
contact with skin or clothes is made, flush with large amounts of
water. If contact with eyes is made, wash eyes with water immed-
iately, and obtain medical aid immediately.
10
Rear axle dif-
a. Mounting surface
Clean
Use clean cloth moistened with cleaning
ferential
solvent P-D-680
companion yoke
b. Rear drive shaft assem-
Position and align
bly, slip yoke (14)
universal joint
end
mounting holes
with companion
yoke mounting
holes
c. Four cap screws (4)
Install
Tighten to 40-50 pounds foot torque
and nuts (3)
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don’t breathe vapors. Do not use near open flame or exces-
sive heat and don’t smoke when using it. Failure to do so could
cause serious injury. If you become dizzy while using cleaning
solvent, get fresh air immediately, and get medical attention. If
contact with skin or clothes is made, flush with large amounts of
water. If contact with eyes is made, wash eyes with water immed-
iately, and obtain medical aid immediately.
11
Transmission
a. Mounting surface
Clean
Use clean cloth moistened with cleaning
output flange
solvent P-D-680
b. Rear drive shaft assem-
Position and align
bly, splined yoke (13)
universal joint mount-
ing holes with output
flange mounting holes
c. Four cap screws (2) and Install
Tighten to 40-50 pounds foot torque
nuts (1)
12
Rear drive shaft
Lubrication fittings
Service
Refer to step 1 above
assembly
2-246
|