TM  10-3930-638-24&P 2-39.   AXLES   AND   DRIVE   SHAFT   ASSEMBLIES   MAINTENANCE   (cont) c. Rear Drive Shaft Assembly (cont). STEP LOCATION ITEM ACTION REMARKS SERVICING 1 Universal joints Lubrication  fittings a. Clean Use clean cloth and remove dirt and grease (9) and slip yoke (5 and 6) (14) CAUTION Don’t use a high pressure grease gun to apply lubricant to grease fittings (5). Use of a high pressure grease gun will cause seals to  rupture. b. Lubricate Refer  to  current  lubrication  order;  lubricate until grease oozes out of fitting REMOVAL 2 Transmission Four nuts (1) and cap Remove output  flange screws (2) 3 Rear axle a. Four nuts (3) and cap Remove differential screws  (4) companion  yoke b. Rear drive shaft Push  two  sections assembly together,  then remove DISASSEMBLY 4 Rear drive shaft a. Lubrication fittings Remove assembly (5 and 6) b. Eight nuts (7) and cap Remove screws (8) c. Universal joints (9) Remove d. Cap (10) Loosen and slide back on splined yoke  (13) e. Washers(11 and 12) Slide back on splined yoke (13) f.  Splined  yoke  (13) Remove; then remove  and discard washers (11 and 12) and cap (10) 2-244