| |
TM 10-3930-638-24&P
2-39. AXLES AND DRIVE SHAFT ASSEMBLIES MAINTENANCE (cont)
b. Center Drive Shaft Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION/REPLACEMENT
WARNING
10
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes. and clothes
and don’t breathe vapors. Do not use near open flame or exces-
sive heat and don’t smoke when using it. Failure to do so could
cause serious injury. If you become dizzy while using cleaning
solvent, get fresh air immediately, and get medical attention. If
contact with skin or clothes is made, flush with large amounts of
water. If contact with eyes is made, wash eyes with water immed-
iately, and obtain medical aid immediately.
Drive shaft sup-
a. Mounting surfaces
Clean
Use clean cloth moistened with cleaning
port bearing
solvent P-D-680
b. Slip yoke (10)
Position and align
universal joint
mounting holes
with front drive
shaft yoke
mounting holes
c. Four cap screws
Tighten to 40-50 pounds foot torque
11
12
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don’t breathe vapors. Do not use near open flame or exces-
sive heat and don’t smoke when using it. Failure to do so could
cause serious injury. If you become dizzy while using cleaning
solvent, get fresh air immediately, and get medical attention. If
contact with skin or clothes is made, flush with large amounts of
water. If contact with eyes is made, wash eyes with water immed-
iately, and obtain medical aid immediately.
Transmission
a. Mounting surfaces
Clean
Use clean cloth moistened with cleaning
parking brake
solvent P-D-680
flange
b. Splined yoke (9)
Position; push/pull
two sections of drive
shaft then align uni-
versal joint mounting
holes with brake
flange mounting holes
c. Four cap screws
Install
Tighten to 40-50 pounds foot torque
Center drive
Lubrication fittings
Service
Refer to step 1 above
shaft assembly
2-242
|
