| |
TM 10-3930-638-24&P
2-39. AXLES AND DRIVE SHAFT ASSEMBLIES MAINTENANCE (cont)
b. Center Drive Shaft Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
CLEANING
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes. and clothes
and don’t breathe vapors. Do not use near open flame or exces-
sive heat and don’t smoke when using it. Failure to do so could
cause serious injury. If you become dizzy while using cleaning
solvent, get fresh air immediately, and get medical attention. If
contact with skin or clothes is made, flush with large amounts of
water. If contact with eyes is made, wash eyes with water immed-
iately, find obtain medical aid immediately.
5
Universal joint (3)
Clean
Use clean cloth moistened with cleaning
solvent P-D-680
6
All other parts
Clean
Use cleaning solvent P-D-680
INSPECTION
7
Universal joint (3),
Inspect
Replace if cracked, threads damaged,
splined yoke (9),
splines twisted, teeth broken, bent, or
and slip yoke (10)
otherwise damaged. Remove burrs with
soft honing stone or crocus cloth
8
All other parts
Inspect
Replace if cracked or threads damaged
REASSEMBLY/REPAIR
9
Center drive shaft a. Cap (6), washers
Position on splined
assembly
(7 and 8)
yoke (9)
b. Splined yoke (9)
Insert into slip
yoke (10)
c. Washers (7 and 8) and
Position against
cap (6)
slip yoke (10);
tighten cap (6)
d. Lubrication fittings
Install
(4 and 5)
c. Two universal joints
Position
(3)
Install
f. Eight cap screws (2)
Install
and nuts (3)
2-241
|