| |
TM 10-3930-638-24&P
2-39. AXLES AND DRIVE SHAFT ASSEMBLIES MAINTENANCE (cont)
a. Front Drive Shaft Assembly and Support Bearing (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
SERVICING
1
Drive shaft
Lubrication fitting
a. Clean
Use clean cloth and remove dirt and
support
grease
bearing (9)
b. Lubricate
Refer to current lubrication order;
lubricate until grease oozes out of
bearing
CAUTION
Don’t use a high pressure grease gun to apply lubricant to lubrication
fitting (14). Use of a high pressure grease gun will cause seals
to rupture.
2
Universal joint
Lubrication fitting (14
a. Clean
Use clean cloth and remove dirt and
(17) and yoke (4) and (13)
grease
b. Lubricate
Refer to current lubrication order;
lubricate until grease oozes out of fitting
REMOVAL
3
Drive shaft
a. Center drive shaft
Disconnect from
Para 2-39b, step 2
support bearing
front drive shaft
yoke (4)
b. Cotter pin (1)
Remove
c. Nut (2) and washer (3)
Remove
d. Yoke (4)
Remove
Use puller
e. Four nuts (5), lock
Remove
washers (6), and cap
screws (7)
f. Two setscrews (8)
Remove
g. Drive shaft support
Remove
bearing (9)
4
Front axle
a. Four cap screws (11)
Remove
differential
b. Front drive shaft
Remove by moving
companion yoke
assembly (12)
towards rear,
dropping it down-
ward and pulling
forward
c. Collar (10)
Remove
DISASSEMBLY
5
Yoke (4)
Lubrication fitting (13)
Remove
6
Front drive shaft
a. Lubrication fitting (14) Remove
assembly
b. Four nuts ( 15) and cap Remove
screws (16)
c. Universal joint (17)
Remove
2-235
|
