TM  10-3930-638-24&P 2-38.   TRANSMISSION   MAINTENANCE   (cont) f. Transmission Hoses, Lines and Fittings (cont). STEP LOCATION ITEM ACTION REMARKS REMOVAL 1 Engine  com- a. Nut (1) Loosen partment b. Transmission to cooler Disconnect  and hose  (2) cap c. Straight connector (3) Remove Plug transmission hole d. Nut (4) Loosen e. Cooler to transmission Disconnect  and hose  (5) cap f. Straight connector (6) Remove Plug transmission hole g. Nut (7) Loosen h. Transmission to cooler Disconnect  and Plug  transmission  to  cooler  tube hose (2) remove assembly  (8) i. Nut (9) Loosen j.  Cooler  to  transmission Disconnect  and Plug  cooler  to  transmission  tube hose  (5) remove assembly (10) k. Cap screw (11), lock Remove washer  (12),  and nut (13) l. Hose clamp (14) Remove 2 Transmission a. Nut (15) Loosen cooler, bottom b. Transmission to cooler Disconnect  and Plug cooler hole tube assembly (8) remove C. Elbow  (16) Remove d.  Pipe  nipple  (17) Remove e. Nut (18) Loosen f. Cooler to transmission Disconnect  and Plug  cooler  hole tube assembly (10) remove g.  Elbow  (19) Remove h. Pipe nipple (20) Remove CLEANING 3 Hoses (2 and 5) Clean Use clean diesel fuel and dry thoroughly WARNING Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use near open flame or exces- sive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning solvent,  get  fresh  air  immediately,  and  get  medical  attention.  If contact with skin or clothes is made, flush with large amounts of water.  If  contact  with  eyes  is  made,  wash  eyes-with  water  immed- iately,  and  obtain  medical  aid  immediately. 2-230