TM  10-3930-638-24&P 2-38.   TRANSMISSION   MAINTENANCE   (cont) c. Axle Disconnect Lever (cont). STEP LOCATION ITEM ACTION REMARKS REMOVAL 1 Operator’s  com- a. Knob (1) Remove partment, rear b. Cotter pin (2) Remove  and  dis- card c. Pin (3) Remove d. Upper lever (4) Remove 2 Transmission a. Nut (5), lock washer Remove (6), and cap screw (7) b. Clamp (8) Remove c. Cotter pin (9) Remove  and  dis- card d. Washer (10) Remove e. Rod (11) Remove NOTE Perform steps f through i only if bracket (19) requires replacement. f. Nut (12), lock washer Remove (13),  washer  (14), and cap screw (15) g. Clamp (16) Remove h. Two cap screws (17) Remove and lock washers (18) i.  Bracket  (19) Remove CLEANING WARNING Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use near open flame or exces- sive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air immediately, and get medical attention. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water immed- iately, and obtain medical aid immediately. 3 All parts Clean Use  cleaning  solvent  P-D-680;  dry thoroughly 2-223