TM  10-3930-638-24&P 2-38.   TRANSMISSION   MAINTENANCE   (cont) b.  Transmission  Linkage  Controls  (cont). 14 STEP LOCATION ITEM ACTION REMARKS INSTALLATION/REPLACEMENT   (cont) f. Inner bellcrank (39) Position (Cont) g. Outer bellcrank (38) Position h. Washer (37) Position i. Two nuts (36) Install 15 Outer  bellcrank a. Two nuts (35) Install on cables (38), inner bell- (53,54) crank (39) b. Two clevises (34) Install and position c. Two clevis pins (33) Install d. Two cotter pins (32) Install e. Two links (31) Position 16 Link (31) a. Four cap screws (30) Install b. Four spacers (29) Install c. Four washers (28) Install d.  Four  lock  washers  (27)  Install e. Four nuts (26) Install NOTE Install four cap screws (30), spacers (29), washers (28), lock washers (27) and nuts (26) to attach links (31) to control valve spools, outer bellcrank (38) and inner bellcrank (39). 17 Instrument panel a. Two cables (53, 54) Attach to bracket and tighten cable nuts b. Two nuts (25) Install on cables (53, 54) c. Control lever (24) Install d. Control lever knob (23) Install e. Control lever (24) Position  between two brackets f. Two washers (22) Position g. Cap screw (21) Install h. Nut (20) Install i. Clevis (19) Install in cable (54) and  position  lever (24) tab j. Clevis pin (18) Install k. Cotter pin (17) Install l. Control lever knob (16) Install m. Speed control lever ( 15) Install n. Nut (14) lnstall on speed control lever (15) o. Cap screw (12) Install p. Spacer (11) Install q. Spring (10) Install r. Bracket (8) Install s. Washer (9) Install 2-218