TM  10-3930-638-24&P 2-38.   TRANSMISSION   MAINTENANCE   (cont) b.  Transmission  Linkage  Controls  (cont). STEP LOCATION ITEM ACTION REMARKS CLEANING 8 Cables (53, 54) and con- Clean Use clean diesel fuel. Dry thoroughly trol lever balls (16, 23) WARNING Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use near open flame or exces- sive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning solvent,  get  fresh  air  immediately,  and  get  medical  attention.  If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water immed- iately,  and  obtain  medical  aid  immediately. 9 All other parts Clean Use cleaning solvent P-D-680. Dry thoroughly INSPECTION/REPAIR 10 Cables (53, 54) Inspect Replace if cracked, worn, damaged, twisted  or  distorted 11 Spring (10) Inspect Replace if cracked, worn, damaged, distorted  or  permanently  set 12 All other parts Inspect Replace if cracked, worn, damaged, distorted,  or  missing  or  damaged  threads INSTALLATION/REPLACEMENT 13 Operator’s  com- a. Two cables (53, 54) Position partment,  under b. Two tie straps (52) Install floor  panel c. Two cable clamps (51) Position d. Two cable hold down Position plates (50) e. Three spacers (47) Install f.  Clamp  (49) Position g. Washer (55) Position h. Four cap screws (48) Install i. Four lock washers (46) Install j. Four nuts (45) Install 14 Transmission a. Cable bracket (44) Position b. Two lock washers (43) Position c. Two cap screws (42) Install d. Stud (41) Install e. Spacer (40) Position 2-217