| |
TM 10-3930-638-24&P
2-30. LIGHT SYSTEMS MAINTENANCE (cont)
a. Flood Lights (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
INSPECTION (cont)
6
All wiring
Inspect
Replace if insulation frayed, or if
conductors broken
7
Rubber gasket (1), seals
Inspect
Replace if cracked or deteriorated
(5 and 8) and
grommet (10)
8
Housing (9)
Inspect
Replace if cracked or if threads damaged
INSTALLATION/ REPLACEMENT
9
Front or rear
a. Grommet (10)
Slide over
On ROPS only
harness lead
and install
NOTE
Mark a spot for a drain hole on bottom of housing (9). Using
1/4 inch drill bit, drill hole at mark. Apply paint around hole
to stop rust and corrosion.
b. Seal (8) and housing
Position on
Seal (8) not used on instrument panel-
and spacer (9)
vehicle
mounted flood lights
c. Washer (11), lock
Slide over
Until flood light housing (9) is securely
washer (7), nut (6)
connector (4)
mounted. Seal (5) used on ROPS
and seal (5)
and tighten
mounted flood lights only
d. Connector (4)
Push in
Harness lead
e. Rubber gasket (1)
Pull over lamp (3)
f. Wire leads (2)
Push on
Lamp terminals
g. Rubber tangs of
Push into cutouts Use a screwdriver to fully position tangs if
gasket (1)
in housing (9)
necessary
TESTING
10
Instrument panel a. IGNITION switch
Place in ON
position
b. VEHICLE LIGHTS
Place in SER.
switch
DRIVE
position
c. FRONT FLOOD
Place in ON
switch or REAR
position
FLOOD switch as
appropriate
11
Front or rear
Flood lights
Check
Front or rear flood lights should be on;
if flood lights are on, place IGNITION,
FRONT FLOOD or REAR FLOOD,
and VEHICLE LIGHTS switches in
OFF positions
NOTE
If flood lights are not on, refer to troubleshooting, paragraph
2-24 and troubleshoot light systems.
2-146 Change 2
|