| |
TM 10-3930-638-24&P
2-28. INSTRUMENT PANEL MAINTENANCE (cont)
b. START Switch and VEHICLE LIGHTS Switch (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
1
Instrument panel, a. Wire leads (1)
Grasp and
From START switch
left of steering
disconnect
column
b. Rubber boot (2)
Unscrew and
Support START switch
remove
c. START switch (3)
Lower and
From instrument panel
remove
d. Nut (4), two screws (5), Remove
From START switch
washers (6) and
terminals (7)
e. Harness connector (8)
Unscrew and
From VEHICLE LIGHTS switch
disconnect
f. Three screws (9), lock
Remove
washers (10) and
lever (11)
g. Four screws (12) and
Remove
Support VEHICLE LIGHTS switch
lock washers (13)
h. VEHICLE LIGHTS
Lower and
From instrument panel
switch (14)
remove
CLEANING
2
Switches (3 and 14),
Clean
Wipe with clean, dry cloth
rubber boot (2) and
harness connector (8)
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and dont breathe vapors. Do not use near open flame or
excessive heat and dont smoke when using it. Failure to do so
could cause serious injury. If you become dizzy while using
cleaning solvent, get fresh air immediately, and get medical
attention. If contact with skin or clothes is made, flush with large
amounts of water. If contact with eyes is made, wash eyes with
water immediately, and obtain medical aid immediately.
3
Switch terminals and
Clean
Use cleaning solvent P-D-680 on
wire connectors
terminals and connectors only
WARNING
Wear safety glasses when drying parts with compressed air.
Failure to do so could cause serious injury to eyes and possible
blindness. If you hurt your eyes or if a foreign object is blown
into your eyes, seek medical attention immediately.
2-131
|