| |
TM 10-3930-638-24&P
2-27. STARTING SYSTEM MAINTENANCE (cont)
b. Starter Relay and-25 AMP Circuit Breaker (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
1
Engine compart-
a. Nut (1), lock washer
Tag and remove
From relay center terminals
ment rear, left
(2) and wire
side of vehicle
b. Two nuts (3), lock
Tag and remove
From relay end terminals
washers (4) and four
wires
c. Two cap screws (5),
Remove
Support relay (8) and mounting plate (15)
lock washers (6) and
flat washers (7)
d. Starter relay (8)
Remove
From mounting plate (15)
e. Two nuts (9), lock
Tag and remove
From circuit breaker terminals
washers (10) and
three wires
f. Two nuts (11), lock
Remove
Support circuit breaker (14) and
washers (12) and
mounting plate (15)
screws (13)
g. Circuit breaker (14)
Separate
and mounting
plate (15)
CLEANING
2
Starter relay (8) and
Clean
Wipe exterior with clean, dry cloth
circuit breaker (14)
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don’t breathe vapors. Do not use near open flame or
excessive heat and don’t smoke when using it. Failure to do so
could cause serious injury. If you become dizzy while using
cleaning solvent, get fresh air immediately, and get medical
attention. If contact with skin or clothes is made, flush with large
amounts of water. If contact with eyes is made, wash eyes with
water immediately, and obtain medical aid immediately.
3
Wire connectors and
Clean
Use cleaning solvent P-D-680 on
terminals
connectors and terminals only
WARNING
Wear safety glasses when drying parts with compressed air.
Failure to do so could cause serious injury to eyes and possible
blindness. If you hurt your eyes or if a foreign object is blown
into your eyes, seek medical attention immediately.
2-125
|