| |
TM 10-3930-638-24&P
2-27. STARTING SYSTEM MAINTENANCE (cont)
a. Starter (cont).
i. Starter
STEP
LOCATION
ITEM
ACTION
REMARKS
TESTING (cont)
8
Disconnect from
(cont)
test setup; con-
nect field coil
lead to solenoid
M terminal and
install starter
(step 9 below)
INSTALLATION/REPLACEMENT
9
Engine compart-
a. Starter (12) and
Position
ment rear, left side
ground cable (11)
of vehicle
b. Three lock washers
Install and
(10) and cap screws
tighten
(9)
c. Two cables (6 and 7),
Install and
On terminal B of solenoid switch
wire (8), lock washer
tighten
(5) and nut (4)
d. Wire (3), lock washer
Install and
On terminal S of solenoid switch
(2) and nut (1)
tighten
e. Terminals B, M, and S Seal
Use silicone rubber sealer
of solenoid switch
2-123
|