TM  10-3930-638-24&P 2-15.   FUEL   SYSTEM   MAINTENANCE   (cont) i. Accelerator/Throttle Control (cont). STEP LOCATION ITEM ACTION REMARKS INSTALLATION/REPLACEMENT (cont) 13  (cont) h. Two washers Install (5), lock washers  (4), and nuts (3) i. Ball joint (2) Install On accelerator cable (8) then connect to fuel injection pump throttle lever j. Nut (1) Install adjustment 4 Engine  com- a. Nut(1) Remove partment b. Ball joint (2) Disconnect From fuel injection pump throttle lever c. Ball joint (2) Adjust  and Adjust for minimum slack in accelerator connect cable by threading further onto ca- ble (8); increase slack by threading out of accelerator cable. Tighten nut (29) NOTE When connecting ball joint (2) to throttle lever be sure you don’t move throttle lever. Connect to throttle lever; if all slack in cable has been removed, reinstall nut (1) NOTE If too much or not enough slack in accelerator cable, per- form step 15. 5 Operator’s a. Two nuts (26) Remove compartment and lock wash- er (27) b. Ball joint (28) Disconnect From accelerator pedal (40) c. Ball joint (28) Adjust and Adjust  for  minimum  slack  in  accelerator connect cable by threading further onto cable (8);  increase  slack  by  threading  out of accelerator cable. Tighten nut (29) NOTE When connecting ball joint (28) to accelerator lever, be sure you don’t move throttle lever. Connect to accelerator pedal and check slack; if too much or too little slack, repeat above adjustment. Reinstall two nuts (26) and lock washer (27). Repeat  step  14  if  necessary. 2-70