 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
4-4.
TRANSMISSION
MAINTENANCE
(cont)
b. Converter Housing (cont)
REMARKS
ACTION
ITEM
LOCATION
STEP
REASSEMBLY (cont)
Tap in position with soft hammer
a. Pin (27) and reverse
Install
Converter
idler gear shaft (26)
housing,
Place lockball (25) in position on gear
b. Idler gear shaft (24)
Install
rear
shaft (24), then, insert gear shaft through
and lockball (25)
its hole in rear of housing and tap into
position with soft hammer
Apply loctite to threads
Install
c. Stud (22 and 23)
Install
d. Transmission temper-
ture switch (20)
and lock washer
(33)
e. Pipe plug (21)
Install
Position sleeve with tab aligned with cast
Position
f. Converter housing
slot in converter housing. Press sleeve
sleeve { 19 )
into housing until it shoulders in housing
as shown. Use two inches diameter bar
stock
Expander spring gap must be 180 degrees
a. Expander spring
Install
Stator
from piston ring hook joint
(18)
support
b. Piston ring (17)
Install
NOTE
In the following step, part number etched on bearing must be up.
Press using suitable size sleeve
Install
c. Bearing
Install
d. Retaining ring (7)
Align holes in support with converter
Position
Converter
a. Stator support (15)
22
housing holes, then tap support into pos-
housing,
ition as shown
rear
4-159
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals