REASSEMBLY (cont) - TM-10-3930-638-24-P0901

TM 10-3930-638-24&P

4-3. FUEL SYSTEM MAINTENANCE (cont)

b. Fuel Injection Pump (cont).

REMARKS

ITEM

ACTION

LOCATION

STEP

REASSEMBLY (cont)

NOTE

(cont)

In following steps where grease is used to keep parts together to

ease assembly, use grease sparingly as it can plug return fitting

and pump will not bleed air from housing during start-up.

g. Governor

Assemble

Assemble these four parts on bench. Apply

spring (45)

a small amount of grease to these parts to

h. Spring retainer (46)

Assemble

keep them in place while assembling.

i. Idle spring (47)

Assemble

Loosen guide stud and withdraw it just

j. Idling spring

Assemble

enough to install these parts on it.

guide (48)

Tighten guide stud to 110-115 pounds

inch torque

k. Two washers

Install

On throttle shaft assembly (37) and shutoff

(35 and 39)

shaft (33). Apply a light film of grease to

and seals

each seal

(34 and 38)

1. Throttle shaft

Partially through its bore

Install

assembly (37)

m. Throttle shaft

Install

Slide over throttle shaft assembly (37) so

lever (36)

that projection in lever (36) bore engages

keyway in shaft (37). Position forked end

of lever (36) so that it straddles guide stud

(44)

4-123