 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
4-3. FUEL SYSTEM MAINTENANCE (cont)
b. Fuel Injection Pump (cont).
REMARKS
ITEM
ACTION
LOCATION
STEP
REASSEMBLY (cont)
Invert in vise
h. Pump and
30
fixture
so bottom
(cont)
faces upward
Install
On head locating screw (64)
i. Two seals (65)
Install
Tighten to 180-220 pounds inch torque
j. Head locating
screw (64)
Install
Use tools P/N 15499 and 15500; tighten to
k. Cam advance
440-460 pounds inch torque
screw (80)
Into groove of power piston (77)
l. Seal (78)
Assemble
m. Piston ring (79)
Into groove of power piston (77)
Assemble
n. Two seals (69)
Into grooves of advance piston hole plug
Assemble
(68)
Into grooves on power piston hole plug (74
o. Two seals (75)
Assemble
On spring (72); use small amount of grease
p. Shim (73)
Assemble
to hold in position
q. Advance adjusting
Install
In piston (71)
spring (72)
r. Piston (71)
Assemble
To advance piston hole plug (68)
s. Slide washer (70)
Install
On piston (71); use small amount of grease
applied to piston end to keep slide washer
in position
t. Advance piston
Install
Finger tighten
hole plug (68)
u. Power piston (77)
Assemble
To power piston hole plug (74); use tool
P/N 16199
v. Slide washer (76)
Assemble
To power piston (77); use small amount of
grease applied to piston end to keep slide
washer in position
w. Power piston
Install
Finger tight
hole plug (74)
NOTE
Power piston (77) is installed in side of housing marked C for a
clockwise rotating pump.
x. New seal (67)
Install
On advance screw hole plug (66)
Install
y. Advance screw
Tighten to 180-220 pounds inch torque
hole plug (66)
using tool P/N 14490
z. Advance piston
Tighten to 215-265 pounds inch torque
Tighten
hole plug (68)
and power piston
hole plug (74)
4-120
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals