INSPECTION (cont) - TM-10-3930-638-24-P0886

TM 10-3930-638-24&P

4-3. FUEL SYSTEM MAINTENANCE (cont)

b. Fuel Injection Pump (cont).

EXAMINE FOR

SPECIFICALLY

LOCATION

STEP

ITEM

INSPECT

INSPECTION (cont)

WARNING

cont)

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immedi-

ately, and obtain medical aid immediately.

e. Pumping

Hold rotor under clean oil and

plungers

insert plungers into their

(122)

bore. With your thumb and

forefinger over shoe slots,

tilt from side to side several

times to determine complete

freedom of movement. Re-

versing or interchanging ini-

tial positions may be neces-

sary as these are matched

parts. If plungers are sticking,

but not visibly damaged, clean

both plungers and bore with

a soft brush and cleaning sol-

vent P-D-680

4-108