DISASSEMBLY (cont) - TM-10-3930-638-24-P0883

TM 10-3930-638-24&P

4-3. FUEL SYSTEM MAINTENANCE (cont)

b. Fuel Injection Pump (cont).

REMARKS

ITEM

LOCATION

ACTION

STEP

DISASSEMBLY (cont)

CAUTION

(cont)

In following step, don't handle rotor shank.

Remove

r. Rotor (123)

Remove

a. Four screws (124)

Housing

Remove

(133)

b. Two timing

line covers (125)

Remove

c. Two timing

and discard

line cover

gaskets (126)

If necessary

Remove

d. Two screws

(127)

If necessary

Remove

e. Nameplate (128)

Hydraulic

head (81)

NOTE

Don't perform following steps unless vent wire and retainer are

damaged.

If damaged

Remove

a. Plug screw (129)

If damaged

Remove

b. Two plug screws

(130)

If damaged. Grasp hydraulic head in your

Remove

c. Vent wire

hand and shake vent retainer into other

retainer (131)

hand

Use tool P/N 18264

Remove

d. Vent wire (1 32)

Use proper size sleeve

Remove only

Two bushings (134)

Housing

if damaged

(133)

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immedi-

ately, and obtain medical aid immediately.

Use cleaning solvent P-D-680

Clean

All parts

4-105