 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
4-2. ENGINE MAINTENANCE (cont)
h. T1ming Gear Cover (cont).
REMARKS
ACTION
ITEM
LOCATION
STEP
INSTALLATION (cont)
17
(cont)
Tighten to 3542 pounds foot torque
Tighten
c. Two cap screws (7)
Use feeler gauge to check running clearance
Check
d. Thrust plate (9)
between thrust plate (9) and idler gear
(11). Clearance must be 0.003 inch. If
clearance is not 0.003 inch remove cap
screws (7), shim(s) (10), thrust plate
(9), and lock plate (8) as an assembly.
Remove and measure thickness of shim(s)
using micrometer. Add or remove shim(s)
as necessary to obtain correct clearance.
Install shim(s), thrust plate, lock plate
and cap screws as an assembly. Tighten
cap screws to 3542 pounds foot torque
Bend tabs on lock plate to lock cap screws
Bend
e. Lock plate (8)
(7)
Use screwdriver
Hold
a. Cam gear
Idler gear 11)
18
Use dial indicator installed to check back-
Check back-
b. Idler gear (11)
lash. Backlash shall not exceed 0.006
lash
inch; if backlash exceeds this dimension,
replace gear (11)
Change 1 4-67
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals