 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
4-2. ENGINE MAINTENANCE (cont)
h. Timing Gear Cover (cont).
REMARKS
ITEM
ACTION
LOCATION
STEP
INSTALLATION (cont)
Coat
a. Cylinder block
Apply Permatex 2 on both sides of cyl-
Cylinder block
12
inder block from lower mounting
hole, downwards
Install and
Apply Permatex 2 to open face of gasket
b. Gasket (30)
from lower mounting hole, downwards
coat
Position
Timing gear cover (27)
Cylinder block
13
Install
1-1/4 inch long cap screw; install in
a. Cap screw (21)
14
Timing gear
and washer (25)
cover boss 1, 2, and 9. Tighten to
cover (27)
25-30 pounds foot torque
Install
3-1 /4 inch long cap screw; install in cover
b. Three cap screws
boas 3,4, and 5. Tighten to 25-30 pounds
(19), washers (20),
foot torque
washers (18), and
nuts (17)
Install
1-1/2 inch long cap screw; install in cover
c. Cap screw (22) and
two washers (25 and
boss 8. Tighten to 25-30 pounds foot
torque
26)
Install
2-3/4 inch long cap screw; install in cover
d. Cap screw (23) and
boss 7. Tighten to 25-30 pounds foot
washer (25)
torque
e. Cap screw (24)
Install
3 inch long cap screw; install in cover boss
6. Tighten to 25-30 pounds foot torque
and washer (25)
Install
f. Two cap screws (15)
Tighten to 25-30 pounds foot torque
and lock washers (16)
Trim
Cut off any protruding gasket from bottom
g. Gasket (30)
of cylinder block. Gasket must be flush
with cylinder block
Change 1 4-65
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals