 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
4-2. ENGINE MAINTENANCE (cont)
d. Crankshaft and Main Bearings (cont).
REMARKS
ACTION
ITEM
LOCATION
STEP
INSTALLATION (cont)
If end play is greater than this dimension,
5
replace center main bearing liners and
(cont)
recheck end play. If end play is still
greater than 0.015 inch, replace crank-
shaft (8)
Clean bearing liner with clean, lintless
Position
Plasti gage
Connecting
16
cloth; position plasti gage crosswise on
rod bearing
liner
cap and liner
(2)
Use clean, lintless cloth
Clean
a. Crankshaft (8)
Cylinder
17
connecting rod
block
journals
NOTE
Install connecting rod bearing caps in proper numbered position
with numbered side of cap towards camshaft.
Position
b. Four connecting
rod bearing
caps (2)
Tighten to 45-50 pounds foot torque; then
Install and
c. Eight connecting
remove
remove
rod nuts (1)
Remove
d. Four connecting
rod bearing
caps (2)
4-35
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals