 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
4-2. ENGINE MAINTENANCE (cont)
a. Cylinder Block Assembly (cont).
REMARKS
ITEM
ACTION
LOCATION
STEP
INSPECTION (cont)
Replace if bent, cracked, or dented
Dipstick tube (13)
Inspect
11
Replace if deformed or nicked
Dowel ring (4)
Inspect
12
Replace if threads are damaged
All other parts
Inspect
13
REASSEMBLY
Position
a. Plate (18)
14
Cylinder
Install
b. Screw (17)
block (19),
Position
c. Clip (16)
side
d. Lock washer (15)
Install
and screw (14)
If removed. Chill in dry ice and install
e. Dipstick tube (13)
Install
smooth end in block until firmly seated
f. Plugs (10, 11,
Install
and 12)
Plug (9)
Install
15
Cylinder
block (19),
rear
Install from rear until flush with front of
a. Cup plug (8)
Install
16
Cylinder
block
block (19),
Install
front
b. Oil gallery plug (7)
If removed. Install from front of block.
c. Oil filter to block
Install
Use 3/4 inch diameter sleeve and install
adapter (5)
until firmly seated
If removed. Install with lip towards front
d. Plug (6)
Install
of block; use 1 inch diameter sleeve and
install until firmly seated
If removed. Cool in dry ice. Install until
Install
e. Dowel ring (4)
firmly seated
In cylinder sleeve bottom grooves
a. Install
17
O-ring (2)
Cylinder
Use No. 30 oil
b. Lubricate
sleeve (1)
Upper and lower grooves
Clean
18
Cylinder
a. Cylinder sleeve bore
block (19),
top
NOTE
If old sleeves are being reinstalled, install in same location and posi-
tion as they were prior to removal.
Don't rotate sleeve during installation and
b. Cylinder sleeve (1)
a. Install
be careful not to damage O-rings. Use
hand pressure to install
4-7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals